This is a very attractive and functional knob latch set, I am quite pleased, but not right out of the box.
I had to take it apart and install the left swing latch bolt (watch for flying springs). While there I hit the components with spray graphite.
Problem #1 When the latch hits the mortise strike plate it is pushed inward and will not catch.
Solution: Take the latch apart and place a finishing nail under the latch bolt and in front of the two installation screws [they will hold it in place].
Problem # 2 The latch side knob should be shorter (by the depth of the latch) than the rosette side knob. These are both the same: rosette side size. Therefore, the knobs cannot both securely attach to the standard size spindle.
Solution: Clamp the spindle to a piece of wood and mark the hole locations, drill two 3/16 holes through the spindle. I then used standard length set screws, those included are much too short, considering that the threads do not engage and the screw is what holds it on. An oversized spindle should work as well wilth the original set screws.
I have rebuilt all the original rim locks in my house and therefore had the expertise to troubleshoot this one and make it work. I'm quite pleased with the end result.
Screen Door Rim Lock Kit - Includes Keys, Strikes, Rose
Many Finishes Available
Screen Door Rim Lock Kit, Includes Keys, Strikes, Rosette. Traditional Victorian pattern, c. 1870, long used on wood storm doors. Dimensions: Knobs are 2" diameter on a 1/4" spindle. Lock body is 2-7/8" wide x 2-1/8" high x 1/2" thick. Rim Lock Keeper or catch is 3/4" wide x 2-1/8" high. Mortised Keeper, also included, is 1-7/8" high x 7/8" wide. Rosette is 2" diameter. Screws are not included.
This item is usually in stock at our Rochester, New York location and can be shipped out within 24 hours in most cases. If not in stock this item generally ships out from our location in 5-7 days. Rush shipping is available from our location if in stock. International shipping is available for this item.
Dimensions: Knobs are 2" diameter on a 1/4" spindle. Lock body is 2-7/8" wide x 2-1/8" high x 1/2" thick. Rim Lock Keeper or catch is 3/4" wide x 2-1/8" high. Mortised Keeper, also included, is 1-7/8" high x 7/8" wide. Rosette is 2" diameter